This body mount kit includes titanium body mount pads, aluminum outer doubler pads, steel hardware for outer pads, pad mount bushings, strut tabs, injector strut bushings, steel saddles, steel pad bolts and aluminum nuts. The pads in this kit would be bolted to the body.

This body mount option includes the titanium adjustable saddles. With this option, you are able to maintain the correct rocker panel height as the body settles over time. There is a total of 1" of adjustment with this option. This body mount kit includes titanium body mount pads, aluminum outer pads, steel hardware for outer pads, pad mount bushings, strut tabs, injector strut bushings, adjustable titanium saddles, steel pad bolts and aluminum nuts. The pads in this kit would be bolted into the body.

This assembly is used for the rear release option on a funny car body. The M-25-RB slip over the 1/2" x .058 4130, but are NOT welded. These are welded to the rear support bar at time of installation. The tubing blank lengths are as follows: 18" -- 5/16" x .049, & 20" -- 1/2" x .058. Rear Hinges sold seperately, M-120-1 for 3/8" thick, and M-120-1A for 1/4" thick. M-25-1 may be required if this is the first M-25 customer has purchased.

This steel rear release kit meets the new 2008 NHRA Rule requirements for both Fuel and Alcohol classes. Kit includes all tabs, cables, and hardware. The rear hinges are sold separately. For fuel applications see part number M-120-2. For alcohol applications see part number M-120-5R.

This Chute Pack Mount Quick Release Kit, part # M-6046-KIT, includes everything to mount the chute packs to the back of a funny car. The following parts are included in the kit: (Image shows #M-6040, #M-6042, #M-6044, #M-6046-F, #M-209, and #M-1003; not shown are part numbers, #M-1009, #M-1020, #M-1025, and #46CS). The magnesium plate that is included with the kit is flat and would need to be bent by customer if needed. All parts may be purchased separately.