Aluminum tab that bolts to the front spaghetti in a funny car body and supports the 1" vent type latch tube. Requires 2 -- M-121-I to mount. See part number F-145 for complete kit. Made of .190 6061.

These 4130 tabs are used to mount the FC-288 Draglink - Linear Bearing Mount for Funny Car applications. 2 required per application.

This is the tab used for funny car lower a-arm tab assembly. The base width is 1 9/16", the hole size is 11/16" and the height to the center line hole is 0.833". The thickness is 1/8". Made from .125 4130 steel.

Generic tab with a 3/8" hole. The base width of the tab is 1 1/2" and the height to the center line hole is 0.988". The thickness of the tab is 1/8".

Tab is made from 1/8" 4130 and the base width is 1 1/2". The height to the center line hole is 0.988" and the hole size is 1/4". Made from .125 4130 steel.

This 4130 tab is welded to the rear upright of a f/c chassis for the rear tree top tubes to mount to. 4 pcs per car required.The base width of this tab is 1 1/2" and the thickness is 1/8". The hole size is 3/8" and the height of the center line is 1 1/2".

This 3/16" thick tab used for wheelie bar mounts on a T/F car. The tab has a 3/8" hole and humps out on one side.The height to the center line hole is 1.121". Made from .190 4130 steel.

The base width of the tab is 1 1/2" and the thickness is 1/8". The hole size is 1/4" and the height of the center line is 2 5/8". Made from .125 4130 steel.

Tab is made of 1/8" 4130 with a leg bent on 2 sides and a 3/8" hole. The base width is 1 1/4" and the height of the center line is 1.396".

This tab is used on the f/c chute lever mount bracket m-115. The levers bolt to this tab. The base width of this tab is 5/8" and the thickness is 0.090". The hole size is 3/16" and the height of the center line is 0.656".